Safety During Maintenance; Disconnecting And Securing The Lathe; Using Lifting Equipment - Optimum OPTiturn TH4610D Betriebsanleitung

Do not remove the turning chips by hand. Use a chip hook and / or a hand brush to remove

turning chips.
Clamp the turning tool at the correct height and with the least possible overhang.

Turn off the lathe before measuring the workpiece.

The instructions mentioned in these operating instructions have to be strictly observed

during assembly, operation, maintenance and repair.
Do not work on the lathe if your concentration is reduced, for example, because you are

taking medication.
Observe the accident prevention regulations issued by your Employers Liability Insurance

Association or other supervisory authorities responsible for your company.
Inform the supervisor about all hazards or faults.

Stay at the lathe until all movements have come to a complete standstill.

Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work

suit and, if necessary, a hairnet.
1.13

Safety during maintenance

Inform the operators in good time of any maintenance and repair works.
Report all safety-relevant changes and performance characteristics of the lathe. Any changes
must be documented, the operating instructions updated and machine operators instructed
accordingly.

1.13.1 Disconnecting and securing the lathe

Turn off the main switch of the lathe before starting any maintenance or repair work.
Use a padlock to prevent the switch from being turned on without authorization and keep the
key in a safe place.
All machine parts as well as all dangerous voltages are switched off.
Excepted are only the positions which are marked with the adjoining pictogram. These positions
may be live, even if the main switch is switched off.
Attach a warning sign to the lathe.
WARNING!
Live parts and moves of machine parts can injure you or others dangerously!
Proceed with extreme care if you cannot switch off
the lathe by turning off the main switch for necessary procedures (e.g. functional
control).

1.13.2 Using lifting equipment

WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
Check that the lifting and load-suspension equipment are of sufficient load-bearing
capability and are in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities responsible for your company.
Fasten the loads properly.
Never walk under suspended loads!
EN
TH4610 | TH4615 | TH4620
124 Translation of original instruction Version 1.0.6 - 2022-5-17