Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ELR 9000 Series
3.4
Manual operation
3.4.1
Powering the device
The device should, as far as possible, always be switched on using the rotary switch on the front of the device.
Alternatively this can take place using an external cutout (contactor, circuit breaker) of suitable current capacity.
After switching on, the display will first show the company logo, followed by manufacturer's name and address,
device type, firmware version(s), serial number and item number (approx. 3 s). In setup (see section „3.4.3. Con-
figuration via MENU" in the second level menu "General settings" is an option "Input after power ON" in which
the user can determine the condition of the DC input after power-up. Factory setting here is "OFF", meaning that
the DC input on power-up is always switched off. "Restore" means that the last condition of the DC input will be
restored, either on or off. All set values are also restored.
3.4.2
Switching the device off
On switch-off, the last input condition and the most recent set values and input status, as well as activated master-
slave operation are saved. Furthermore, a PF alarm (power failure) will be reported, but has to be ignored here.
The DC input is immediately switched off and after a short while fans will shut down and after another few seconds
the device will be completely powered off.
3.4.3
Configuration via MENU
The MENU serves to configure all operating parameters which
are not constantly required. These can be set by finger touch on
the MENU touch area, but only if the DC input is switched OFF.
See figure to the right.
If the DC input is switched on the settings menu will not be shown,
only status information.
Menu navigation is by finger touch. Values are set using the rotary
knobs. The assignment of the knobs to the adjustable values is not
indicated in menu pages, but there is an assignment rule: upper
value -> lefthand knob, lower values -> righthand knob.
The menu structure is shown schematically on the following pages.
Some setting parameters are self-explanatory, others are not. The
latter will be explained on the pages following.
EA Elektro-Automatik GmbH
Page 46
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de
Werbung
Kapitel
Inhaltsverzeichnis
