Initial Commission; Commission After A Firmware Update Or A Long Period Of Non Use - Elektro-Automatik ELR 9000 Betriebsanleitung

ELR 9000 Series
2.3.12

Initial commission

For the first start-up after purchasing and installing the device, the following procedures have to be executed:
• Confirm that the connection cables to be used are of a satisfactory cross section!
• Check if the factory settings of set values, safety and monitoring functions and communication are suitable for
your intended application of the device and adjust them if required, as described in the manual!
• In case of remote control via PC, read the additional documentation for interfaces and software!
• In case of remote control via the analog interface, read the section in this manual concerning analog interfaces!
2.3.13

Commission after a firmware update or a long period of non use

In case of a firmware update, return of the equipment following repair or a location or configuration change, similar
measures should be taken to those of initial start up. Refer to „2.3.12. Initial commission".
Only after successful checking of the device as listed may it be operated as usual.
EA Elektro-Automatik GmbH
Page 42
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de