H) Epa Function For Steering - Reely Hiker SFX Bedienungsanleitung

h) EPA Function for Steering

With the EPA function (EPA = "End Point Adjustment"), the maximum permissible deflection of the steering servos on
either side (from the neutral position to the left or right) can be determined.
This function is usually used to protect the servo mechanics from mechanical impact with an obstacle at full deflection.
This may lead to overloading of the servo gear, increased power intake and, as a result, overload of the electronics.
The manufacturer has already pre-set the optimal value. Therefore, you should not change the settings.
Proceed as follows:
• Switch on the transmitter. Wait until the display of the battery/rechargeable battery voltage appears and the trans-
mitter is ready for operation.
• Keep the two buttons " " and " " pushed at the same time for one second so that the setting menu is called. The
upper left display shows "
• Push the button " " or " " briefly repeatedly until "
• Move the steering wheel (3) to the left to set the final deflection of the steering servo to the left. The display shows
"L ".
• Change the setting with the button "-" or "+" (set value 0 - 150; keep the corresponding button pushed for quick
adjustment).
• Move the steering wheel (3) to the right to set the final deflection of the steering servo to the right. The display
shows " R".
• Change the setting with the button "-" or "+" (set value 0 - 150; keep the corresponding button pushed for quick
adjustment).
• If you do not push any buttons for 5 seconds, the setting is saved and the setting menu left.
48
".
ST" is displayed.