I) Epa Function For Forward And Reverse Driving - Reely Hiker SFX Bedienungsanleitung

i) EPA Function for Forward and Reverse Driving

The EPA function (EPA = "End Point Adjustment") for forward/reverse driving sets the maximum speed for the forward
and reverse drive.
Proceed as follows:
• Switch on the transmitter. Wait until the display of the battery/rechargeable battery voltage appears and the trans-
mitter is ready for operation.
• Keep the two buttons " " and " " pushed at the same time for one second so that the setting menu is called. The
upper left display shows "
• Push the button " " or " " briefly repeatedly until "
• Move the control lever (2) away from the handle in order to set the maximum speed for reversing. The display
shows " B".
• Change the setting with the buttons "-" or "+" (set value 0 - 150; keep the corresponding button pushed for quick
adjustment).
• Move the control lever (2) towards the handle in order to set the maximum speed for forward driving. The display
shows "F ". Release the control lever again.
• Change the setting with the buttons "-" or "+" (set value 0 - 150; keep the corresponding button pushed for quick
adjustment).
• If you do not push any buttons for 5 seconds, the setting is saved and the setting menu left.
Observe:
If the value is set too low, the vehicle will no longer move, even if you set the control lever to full throttle.
".
TH" is displayed.
49