Manually Creating And Configuring A Standard Voip Account For An Auerswald Pbx - Auerswald COMfortel 2600 IP Inbetriebnahmeanleitung

2.
Tap on DHCP.
3.
Tap on IP address and then enter a permanent IP address for the tele-
phone.
Tip: By tapping on an entry field in the Ethernet menu, you can fade in a
line that helps you enter special characters.
4.
Tap on OK.
5.
Tap on
6.
Tap on OK.
7.
Tap on Gateway and then enter a gateway for the telephone.
8.
Tap on OK.
9.
Tap on DNS server 1 and then enter a DNS server for the telephone.
10.
Tap on OK.
11.
Press the home key to get to the start page.
12.
Tap on No account registered.
13.
Proceed with
Manually Creating and Configuring a Standard VoIP Account for
an Auerswald PBX
Requirements
– Auerswald PBX COMpact 3000 analog/ISDN/VoIP, COMpact 4000,
COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 5000/R or
COMmander 6000/R/RX with the following features:
– Available internal VoIP channels
– Switched on (connected to the 230 V mains supply)
– Internal telephone number entered in the configuration with PIN and pass-
word (COMpact 3000analogue/ISDN/VoIP only PIN) for the telephone
COMfortel 2600 IP/3600 IP - Firmware V2.2 - Setup V03 05/2015
DHCP is switched off.
Net mask and then enter a subnet mask for the telephone.
The message No account registered is shown on the display.
The account overview appears.
Step 5. on page
Commissioning
55.
57