Commissioning The Telephone; Required Settings For Operating The Auerswald Pbx - Auerswald COMfortel 500 Bedienungsanleitung

Commissioning the Telephone

1.
Insert the plug of the connection cable
included in the package, as shown
below in Fig.
with on the bottom of the
telephone.
2.
Guide the cable to the outside through
one of the cable channels. See
Fig. 4: Connection
3.
Turn the telephone around again.
4.
Insert the other plug on the connection
cable into an analogue jack connected
to the PBX or in the analogue
connection jack provided by the
network provider.
Note: Within
accompanying RJ-11-TAE adapter.
Required Settings for Operating the
Auerswald PBX
The telephone can display the existing
information for an incoming call on the
display and save it in the caller list (CLIP).
This includes the telephone number and
name of the caller as well as the date and
time of the call.
Note: A name saved in the PBX
(for example,
memory) is
corresponding entries in the telephone
book on that telephone.
24
4, into the jack marked
Fig.
Germany, use
in the short-code
overridden by
Note: The time saved in the telephone
is overwritten by the information
generated by a call.
In order for the telephone to easily detect
this information, it needs a defined call
signal that must be enabled for the
subscriber when operating an Auerswald
PBX.
4.
Required
Configuration:
Internal telephone number on the
analogue port
Device
telephone"
CLIP info "Yes" or "Yes, also door
terminal number"
Extended CLIP info "activated"
Without CLIP delay block "activated"
Set Flash "100 ms"
the
any
Settings for the
type "analogue,
PBX
DTMF