Connecting The Power Supply Plug(S) (Only Comfortel 3600 Ip) - Auerswald COMfortel 2600 IP Inbetriebnahmeanleitung

Preparation

Connecting the Power Supply Plug(s) (only COMfortel 3600 IP)

Notes on the power supply: If your active network component (switch or
router) supports PoE, the COMfortel 3600 IP can be supplied with power by
Power over Ethernet (PoE). In this case, the jumper must be inserted into
the socket
with key extension modules, the wall-mounted power supply included in the
scope of delivery must be connected to the socket
key extension module.
If PoE is not available, the COMfortel 3600 IP can be supplied with power
by a wall-mounted power supply. In this case, the power supply must be
connected to the socket
jumper has been removed). In this way, a single key extension module can
also be supplied with power. To operate two or more key extension mod-
ules, an additional power supply must be connected to the socket
the bottom of one of the key extension modules.
Warning: Using the wrong power supply plug can result in a life-threaten-
ing electric shock or can damage or destroy the device.
 For this reason, only use a power plug of type no. FW7577/EU/40.
Requirements
– One or two power supply plug(s) with type no. FW7577/EU/40 (only one
power plug is contained in the scope of delivery)
Steps to Take
Note: Do not set up the connection to the 230 V mains supply before the
telephone is actually commissioned.
1.
Only for the operation without Power over Ethernet (PoE): Remove the
bridge plug from the corresponding jack marked with
of the telephone.
2.
Only for the operation without Power over Ethernet (PoE): Insert the RJ-45
connector of the power supply into the jack labelled with
side of the telephone.
3.
Only for the operation with key extension modules: Insert the RJ-45 con-
nector of the power supply into the jack labelled with
of the key extension module.
50
on the bottom of the telephone. To operate the telephone
on the bottom of the telephone (after the
COMfortel 2600 IP/3600 IP - Firmware V2.2 - Setup V03 05/2015
on the bottom of the
on
on the lower side
on the lower
on the lower side