Selecting A Display Language; Registering The Handset For The First Time - Auerswald COMfortel M-530 Betriebsanleitung

Initial Commissioning
1. Put the handset in the charging cradle for 7.5 hours.
2. The rechargeable batteries are fully charged when the lighting flash symbol
goes out in the display.
Caution: The handset must be charged in the charging cradle supplied
with it!
Note: The rechargeable batteries might warm up during charging. This is
not dangerous. For technical reasons, the charging capacity of the
rechargeable batteries reduces over time.

Selecting a display language

1. Press the right-hand side of the control key
3. Press the
The language setting display is displayed. The set
language (e. g. English) is marked (
4. Selecting a different language: Press the control key
language, e.g. Français, is marked in the display.
5. Press the Select key directly under the display to activate the language.

Registering the handset for the first time

These instructions describe how to register the telephone on a base unit for the
first time.
Requirements:
• The base unit is configured as an end device on an Auerswald/FONtevo
PBX.
• At least one VoIP account has been configured for the base unit on the PBX.
Note: The registration must be performed both on the base unit and on
the handset. Both must be performed within 60 seconds. You will find
22
7.5h
and keys, one after the other.
.
= selected).
COMfortel M-530 - Instructions V01 04/2019
2.
Deutsch
English
Français
until the required