Selecting A Display Language; Registering The Handset For The First Time - Auerswald COMfortel M-520 Betriebsanleitung

1. Put the handset in the charging cradle for 7.5
hours.
The rechargeable batteries are fully charged
when the lighting flash symbol
the display.
Caution: The handset must be charged in the charging cradle supplied
with it!
Note: The rechargeable batteries might warm up during charging. This is
not dangerous. For technical reasons, the charging capacity of the
rechargeable batteries reduces over time.

Selecting a display language

1. Press the middle of the control key
2. Slowly press the
other.
The language setting display is displayed. The set
language (e. g. English) is marked (
3. Press the control key
marked in the display.
4. Press the right-hand key directly under the display to activate the language.
5. Exiting the menu: Press the Disconnect key for a long time.

Registering the handset for the first time

These instructions describe how to register the telephone on a base unit for the
first time.
Requirements:
• The base unit is configured as an end device on an Auerswald/FONtevo
PBX.
• At least one VoIP account has been configured for the base unit on the PBX.
Note: The registration must be performed both on the base unit and on
the handset. Both must be performed within 60 seconds. You will find
instructions for performing registration on the base unit in the base unit's
Operating Manual.
When you first commission the handset, the message Please register handset
is displayed when you insert the rechargeable batteries.
1. Perform registration on the base unit.
COMfortel M-520 - Instructions V01 04/2019
goes out in
.
and keys, one after the
until the required language, e.g. Français, is
Initial Commissioning
Deutsch
English
Français
= selected).
23