Once you have put your telephone into operation and configured it, check this section on
operation and configuration for additional useful information.
Querying the Firmware Version/Serial Number
1.
Tap on
2.
Scroll to the desired information.
Performing a Firmware Update from the SD/SDHC Card
Important: You can download current firmware files from the Internet. (see
www.auerswald.de/service).
The Operation Guide of the telephone also describes further variants of the
firmware update.
Requirements
–
Firmware file (*.rom) saved on a SD/SDHC card
–
SD/SDHC card inserted into slot (not included in the scope of delivery)
–
DNS server and, if necessary, HTTP proxy server configured in the PBX
1.
Tap on
2.
Tap on the firmware file (*.rom) displayed under Update from SD card.
3.
Tap on Update.
4.
Tap on:
Further Steps
–
If the description of the new function is missing after the installation of func-
tional extensions by means of a firmware update, you will find current
instruction manuals on the Internet (see www.auerswald.de/service).
–
To use the new features after a firmware update of the telephone, an
update of the PBX firmware is often required (see instructions of the PBX).
COMfortel 2600 IP/3600 IP - Firmware V2.2 - Setup V03 05/2015
Appendix
> Settings > About phone.
> Settings > Update & provisioning.
The message Update is installed, please wait... appears while the
firmware file is loaded into the telephone.
Restart later: The firmware will be activated the next time you restart the
telephone (
> Settings > Shutdown/Reboot > Reboot).
Restart now: The telephone restarts immediately and the new firmware
is activated.
Appendix
63