Manually Creating And Configuring A Standard Voip Account For An Auerswald Pbx - Auerswald COMfortel 1400 IP Inbetriebnahmeanleitung

Tap on Net mask and enter a subnet mask for the telephone.
5.
Tap on OK.
6.
Tap on Gateway and enter a gateway for the telephone.
7.
Tap on OK.
8.
Tap on DNS server 1 and enter a DNS server for the telephone.
9.
Tap on OK.
10.
Press the home key to get to the start page.
11.
Tap on No account registered.
12.
Proceed with
13.
Manually Creating and Configuring a Standard VoIP Account for
an Auerswald PBX
Requirements
– Auerswald PBX COMpact 3000 analog/ISDN/VoIP, COMpact 4000,
COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 5000/R or
COMmander 6000/R/RX with the following features:
Tap on (
1.
Tap on New provider/PBX.
2.
Tap on int Auerswald PBX sub system IPv4 V100.
3.
Tap on Domain and then enter the IP address of the PBX.
4.
Note: To edit incorrect entries, tap on the required entry field and the
Android keyboard with a delete button opens. If you press the back key, the
Android keyboard closes.
COMfortel 1400 IP - Firmware V2.4 - Setup V05 12/2015
The message No account registered is shown on the display.
The account overview appears.
Step 5. on page
PBX put into operation
Available internal VoIP channels
Internal telephone number entered in the configuration with PIN and
password (COMpact 3000 analogue/ISDN/VoIP until firmware 4.0N only
PIN) for the telephone
Apps > Settings > Providers & PBXs).
51.
53