Using the inverter
10.3
Switching to energy-saving mode
I
NOTE
The energy-saving mode can be set with a remote control only.
10.4
Configuring the inverter
You can adjust the device using the DIP switch (fig. 2 4).
Defining settings
Using the S1 dip switch you can define whether the parameter of the setting should
be made using the connection of a CI BUS capable control panel or the dip switches.
Parameter
Remote control connection
Setting the mains voltage
You can set the mains voltage using the S2 dip switch.
Mains voltage
230 V/50 Hz
240 V/60 Hz
18
Dip switch
SinePower
Dip switch
S1
Off
On
DIP switch
S2
Off
On
EN