Technical Specifications - ATIKA MHB 40 Originalbetriebsanleitung

TECHNICAL INFORMATION / TECHNICAL DATA
The so-called "lean" adjustment of carburettors and other
systems utilizes this fact to reduce the emission of carbon
monoxide, nitrogen oxide and hydrocarbons.
Impermissible interventions and modifications
Interventions or modifications to the emission control system may
cause the values to rise above the legal limits. These
interventions include, amongst others:
Removal or modifications of the supply, fuel or exhaust
systems.
Modification or disconnection of the controller or the speed
adjustment to allow the engine to be operated with other
performance ranges than specified by the manufacturer.
Problems that may affect the emission of pollutants
You should have the engine inspected or repaired by your
customer service if you notice the following problems:
Difficult starting or stalling after starting
Irregular idle
Misfiring under load
Afterburning (exhaust backfiring)
Black exhaust gases or high gasoline consumption.
Spare parts
The emission control systems of your engine correspond with the
manufacturer specifications. We absolutely recommend the use
of original spare parts during maintenance. These original spare
parts are manufactured according to the same standards as
original parts, that is, you can rely on their performance. The use
of non-original spare parts and compromised quality may affect
the efficiency of the emission control system.
The manufacturer of such accessory parts is responsible to

11. TECHNICAL SPECIFICATIONS

Modell
Type
Rated output (kW/3600 rpm)
Max. torque (Nm/rpm)
Noise (≤)
Bore x stroke (mm)
Displacement (cm³)
Kompression
Lubrication
Starting
Rotation
Valve play
Spark plug gap
Ignition
Dimensions (length) (mm)
Dimensions (with) (mm)
Dimensions (height) (mm)
Net weight (kg)
26
ensure that the respective part does not have a negative effect
on emissions. The manufacturer of such a part must confirm that
the use of the spare part does not cause the engine to be unable
to meet the pollutant regulations.
Maintenance
Please follow the maintenance plan. Remember that this plan
was developed assuming that you will use your engine according
to the specifications. Continuous operation under full load or the
use in wet or dusty conditions requires more frequent
maintenance.
QUICK INFORMATION
Engine oil
Spark plug
Carburettor
Maintena-
nce
DJ1P65F
Single cylinder, four-stroke, forced air cooling, OHV
2.95
6.5/3000
68 db(A)
65 x 42
140
8.5:1
Splash
Starting with cranking rope
Counterclockwise (from P.T.O. side)
Intake valve:
exhaust valve:
0.7 – 0.8mm
Transistorised magneto ignition
410
370
380
13
SAE 10W-30
API SE or better, for general
Type
use
See engine oil recommendation
Oil capacity 0,6 l
Type F6RTC or equivalent
Gap 0,7 – 0,8 mm
Idling 3600 ± 150 min
Each use Check engine oil; check air
filter
First 20 Change engine oil
hours
After this See "Maintenance"
DJ1P70F
3.6
8/3000
68 db(A)
70 x 45
173
8.5:1
0.10 ± 0.02 mm,
0.15 ± 0.02 mm
0.7 – 0.8mm
430
380
410
14
-1