Transport - ATIKA MHB 40 Originalbetriebsanleitung

STORAGE / TRANSPORT
You can extend the storage time for gasoline by adding an
appropriate stabilizer. However, you can also avoid fuel problems
by emptying the tank and carburettor.
ADDING A GASOLINE STABILIZER TO EXTENT THE
STORAGE TIME OF THE GASOLINE
Before adding a gasoline stabilizer the tank must first be filled
with fresh gasoline. The quality of the gasoline during storage
deteriorates more quickly if the tank is filled only partially. If you
are using a gasoline canister for fuelling, make sure that it
contains only fresh gasoline.
1. Add the gasoline stabilizer according to the instructions of
the manufacturer.
2. After a gasoline stabilizer was added: Let the engine run
outdoors for 10 minutes to make sure that the treated
gasoline has fully replaced the untreated gasoline in the
carburettor.
3. Stop the engine and turn the fuel valve to OFF.
DRAINING THE FUEL TANK AND CARBURETTOR
1. Place a suitable vessel under the carburettor; use a funnel
to prevent spilling gasoline.
2. Unscrew the fuel drain plug and remove it together with the
gasket.
SEAL RING
FUEL DRAIN PLUG
3. Once the fuel has been drained into the container, remount
the fuel drain plug together with the gasket. Tighten all parts.
Storage measures
1. Change the engine oil.
2. Remove the spark plug.
3. Pour a table spoon (5 - 10 ml) of clean engine oil into the
cylinder.
4. Pull the cranking rope several times to distribute the oil in
the cylinder.
5. Screw the spark plug back into place.
6. Pull the cranking rope until you feel a resistance. This closes
the valves to prevent any moisture from entering the
cylinder. Let the cranking rope slide back slowly.
24
CARBURETTOR
If you want to store the engine with gasoline in the carburettor
and tank, it is important to at least reduce the risk of gasoline
vapour ignition. Choose a well ventilated storage area out of
range from devices that may cause or contain flames, such as
water heaters, stoves or laundry driers. Avoid the proximity of
spark-generating electric motors or the operation of electric
power tools.
If possible, avoid storage areas with high humidity to prevent rust
and corrosion.
Turn the fuel valve to OFF to reduce the possibility of gasoline
leaks.
Place the engine on a horizontal surface. A slanted position may
cause oil and fuel leaks.
Once engine and silencer have cooled down, cover the engine to
protect it from dust. A hot engine or silencer may ignite certain
materials or cause them to melt. Do not use a plastic tarp for
covering. A cover from non-breathing material causes moisture to
accumulate around the engine thus promoting the development
of rust and corrosion.
Startup after storage
Inspect the engine according to the instructions in the chapter
"CHECKS BEFORE STARTING"
Fill the tank with fresh gasoline if the fuel has been drained
during storage. If you are storing your gasoline in a canister,
make sure that it contains only fresh gasoline. Gasoline oxidizes
and the quality deteriorates over time, which results in more
difficult starting.
The engine may smoke briefly if it was protected with oil for
storage. This is normal.

8. TRANSPORT

If the engine has been running, allow it to cool for at least 5
minutes before loading the engine-powered machine onto a
transport vehicle. A hot engine and silencer may cause burns and
ignite certain materials.
Keep the engine in a vertical position during transport to prevent
gasoline from running out. Set the fuel valve to OFF.