Boston Scientific RF 3000 Gebrauchsanweisung Seite 17

G
uiDance anD manufacturer
The RF 3000™ Radio Frequency Generator is intended for use in the electromagnetic
environment specified below. The customer or the user of the RF 3000 Radio Frequency
Generator should assure that it is used in such an environment.
i iec 60601
mmunity test
test level
Conducted RF 3 Vrms
IEC 61000-4-6 150 kHz to
80 MHz
Radiated RF 3 V/m
IEC 61000-4-3 80 MHz to
2.5 GHz
note 1 At 80 MHz and 800 MHz, the higher frequency range applies.
note 2 These guidelines may not apply in all situations. Electromagnetic propagation
is affected by absorption and reflection from structures, objects and people.
a Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones
and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be
predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF
transmitters, an electromagnetic site survey should be considered. If the measured field strength in
the location in which the RF 3000 Radio Frequency Generator or any of its components are used
exceeds the applicable RF compliance level above, the RF 3000 Radio Frequency Generator should
be observed to verify normal operation. If abnormal performance is observed, additional measures
may be necessary, such as reorienting or relocating components or the entire RF 3000 Radio
Frequency Generator.
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
b
' –
s Declaration electromaGnetic immunity
c e
ompliance lectromaGnetic environment
level
Portable and mobile RF
communications equipment should
be used no closer to any part
of the RF 3000 Radio Frequency
Generator, including cables, than the
recommended separation distance
calculated from the equation
applicable to the frequency of the
transmitter.
Recommended separation distance:
3 Vrms
3 V/m
where P is the maximum output
power rating of the transmitter
in watts (W) according to the
transmitter manufacturer and d is the
recommended separation distance in
metres (m).
Field strengths from fixed RF
transmitters, as determined by an
electromagnetic site survey,
be less than the compliance level in
each frequency range.
Interference may occur
in the vicinity of
equipment marked
with the following symbol:
17
-
GuiDance
80 MHz to 800 MHz
800 MHz to 2.5 GHz
should
a
b