Fuxtec FX-RMT84M Bedienungsanleitung Seite 69

END OF MOWING
After completion of the mowing process:
•
Disengage the mower,
•
Reduce the engine speed,
•
Raise the cutting unit to the highest cutting height position
•
and drive the machine back to the parking area.
SWITCH OFF ENGINE
•
Bring the machine to a standstill.
•
Set the throttle lever to "SLOW" (idling speed).
•
Turn the ignition key to "OFF" to switch off the engine.
WARNING:
To avoid misfiring, leave the throttle lever in the "SLOW" position for at least 20 seconds before
switching off the engine.
IMPORTANT:
Do not leave the ignition key in the "ON" position when the engine is not running - this can discharge
the battery.
Note:
•
Do not operate the machine if the battery is not charged.
•
Do not operate the machine while the battery is charging.
CLEANING AFTER MOWING
Clean the mowing deck thoroughly after each use to remove grass and dirt residues and extend the
service life of the machine.
WARNING:
Wear suitable eye protection and ensure that no persons or animals are in the vicinity during cleaning.
Cleaning the inside of the mowing deck and discharge chute:
1. Place the machine on firm, level ground.
2. Prepare them according to the last mowing method used.
3. Connect a water hose to the cleaning connections on the mowing deck.
4. Sit in the driver's seat.
5. Lower the mower deck completely.
6. Start the engine and let it idle.
7. Rinse each cleaning opening individually with water while the blades are rotating.
8. Remove the grass catcher, empty and rinse it thoroughly and then set it aside to dry.
Cleaning the upper area of the cutting tool assembly:
1. Lower the mower deck completely.
2. Use compressed air to remove grass and dust residues via the left and right protective
openings.
Manual_FX-RMT84M_FX-RMT92A_Int24_rev01
70