Assembly Of The Grass Catcher - Fuxtec Fx-Rmt84M Bedienungsanleitung

ASSEMBLY OF THE GRASS CATCHER

Proceed as follows to install the grass catcher:
1. Attach the front bracket (3) to the upper frame (2) using 4 screws (M6×35) and 4 nuts (M6).
2. Fit the two lateral inclined support tubes (1) to the top frame (2) and the front bracket (3) using
4 type F screws (M6×35) and 4 nuts (M6).
3. Attach the grass catcher bag (4) to the frame structure.
4. Fit the grass catcher cover (5) to the frame section using 8 screws (ST5.0×35) and 4 screws
(ST5.0×16).
5. Insert the roll-over lever (6) into the cover plate of the grass catcher and secure it with 1 screw
(M6×25) and 1 nut (M6).
Manual_FX-RMT84M_FX-RMT92A_Int24_rev01
58