Transportation - Fuxtec Fx-Rmt84M Bedienungsanleitung

•
In particular, check that the screws on the cutting tools are tight.
•
Always wear suitable work gloves when handling cutting tools (e.g. when removing or
installing).
•
When sharpening the blades, ensure that they are evenly balanced.
•
Work such as dismantling, sharpening, balancing, reassembling or replacing cutting tools
requires specialist knowledge and special tools - this should only be carried out by specialist
companies.
•
Check the function of the brakes regularly and have them serviced or repaired if necessary.
•
Replace illegible or damaged warning and information signs immediately.
•
Lower the cutting device completely if the machine is not to be used for a long period of time
or is to be left unattended.
•
Always keep the machine out of the reach of children.
•
Never store the machine with a full fuel tank in places where fuel vapors could be ignited by
open flames, sparks or heat sources.
•
Allow the motor to cool down completely before parking the appliance indoors.
•
Keep the engine, silencer, battery compartment and the area around the fuel tank free of
grass, leaves, oil and dirt - this helps to prevent the risk of fire.
•
Empty the grass catcher completely after each use. Never store filled grass catcher in closed
rooms.
•
Check regularly whether oil or fuel lines are leaking. Even small leaks can lead to a fire hazard.
•
If the fuel tank needs to be emptied, only carry out this procedure outdoors when the engine
has cooled down.
•
Never leave the ignition key in the ignition lock or in the vicinity of children or unauthorized
persons. Always remove it before carrying out any maintenance work.
Check the following protective and functional parts regularly for damage or wear and replace
defective parts immediately:
•
Lateral ejection protection
•
Rear ejection guard
•
Grass catcher
•
Intake grille

28. TRANSPORTATION

•
WARNING! When transporting the machine with a truck or trailer, use a ramp with sufficient
load-bearing capacity and a suitable width and length.
•
Loading may only be carried out with the engine switched off, the drive deactivated and ideally
with the assistance of other persons .
The following measures are required during transportation:
•
Close fuel tap (if fitted)
•
Fully lower the cutting device or attachments
•
Apply the parking brake
•
Securely fasten the machine to the transport vehicle with sturdy ropes or chains
Manual_FX-RMT84M_FX-RMT92A_Int24_rev01
63