pyrexx XSD200 Gebrauchsanleitung Seite 74

follows:
(1) Pull the activation button up.
(2) Press and hold the testing/stop
button for 2 to 3 seconds.
(3) Bring the device into learning mode
(see chapter 7 "Expanding a radio
group and learning mode" on page
66).
(4) If necessary, reset the device to
the factory settings (see chapter 10
"Restoring default settings" on page
69).
(5) Expand the radio group
(see chapter 7 "Expanding a radio
group and learning mode" on page
66).
Radio group not or no longer Radio group not or no longer
in the learning mode in the learning mode
If a device cannot be connected to a ra-
dio group, and the LED signal lights of the
radio group devices do not flash yellow,
it can be that the radio group is not or is
no longer in the learning mode. To trou-
bleshoot, proceed as follows:
74 User Manual: XSD200 - Smoke Alarm Device with Radio Link
f Bring the radio group into learning
mode (see chapter 7 "Expanding a radio
group and learning mode" on page 66).
Device and radio group in Device and radio group in
the learning mode the learning mode
Although device and radio group are in
the learning mode and the signal LED
flashes yellow, there may be no wireless
connection. To troubleshoot, proceed as
follows:
(1) Check the distance between the
devices, if necessary reduce the
distance.
(2) Reactivate the devices and radio
group.
f Reset all devices to the factory
settings (see chapter 10 "Restoring
default settings" on page 69).
f Reactivate the devices and radio
group (see chapter 6 "Initial activa-
tion and setting up" on page 63).
Defective connection test Defective connection test
of a radio group of a radio group
A defective device in a radio group can
EN
EN