Threading The Machine - Singer 7108 Gebrauchsanweisung

Threading the machine
• Raise the presset foot to release tension
discs and make sure needle and take-up
lever are in highest Position
• Place spool pin feit trom accessones over
spool pin. and place spool of thread on
spool pin with sht A on top
• Keep right hand on spool of thread to hold
firmly in place while threading machine.
• Snap thread into upper thread guide 1
• Pass thread through point 2.
Thread the needle thread tension 3. Slide
thread over metal plate into tension discs.
ead thread under needle thread tension and
through tension wire by firmly pulling thread
Straight up.
Pull thread to right behind point 2 guiding
thread up toward take-up lever.
Pass thread through points 4 to 6 as shown.
Thread needle from front to back and draw
about 10 cm (4 inches) of thread through eye
of needle.
23