Mounting The Wing; L) Completion Of The Elevator Unit - Reely PC9 ARF Montageanleitung

k) Mounting the wing
Push the wing attachment screw with the washer into the screw hole from the
bottom of the wing.
Then put the provided rubber ring onto the screw to prevent it from falling out.
Put the wing onto the fuselage and screw both parts together.
Make sure the wing is properly attached to the fuselage. Segments "A" and "B"
must have the same length.

l) Completion of the elevator unit

Cut the elevator (2) out of the tailplane (1). Proceed as described for the ailerons.
The front edges of the elevators have to be properly treated and sanded down
(see ill. 12. b).
After cutting the slits for the elevator hinges (3) using a box cutter (max. thickness
1 mm), the hinges are glued to the tailplane (1). Use thin superglue for rigid
foam.
After the glue has hardened, attach the elevator to the tailplane without adding
additional glue and check if it fits and works properly.
If it fits, glue the hinges to the elevator. Make sure that the gap between the
elevator and the tailplane is as small as possible.
B
A
A=A
B=B
90°
B
A
Figure 11
Figure 12a
Figure 12b
Figure 12c
33