Installing The Propeller; Installing The Receiver - Reely PC9 ARF Montageanleitung

u) Installing the propeller
First put one of the two washers, then the spinner plate followed by the propeller
and finally the second washer onto the propeller shaft.
Screw on the propeller nut and tighten it using an 8-mm spanner.
Make sure the spinner plate and the propeller (1) are properly
aligned.
Attach the spinner cap and tighten the two locking screws (2).
Turn the propeller manually several times to check if the propeller and the
spinner run smoothly.
v) Installing the receiver
Once you have checked the function of the connected servos and the speed
controller, attach the receiver (1) with double-sided tape or servo tape as
illustrated.
The two cables from the bottom (2) are the cables for the elevator servo and
the rudder servo.
The cable for the aileron servo (3) must be run through the front hole and
connected to the receiver.
The front cable (4) is the connection cable of the speed controller (illustrated
schematically only).
The aerial wire (5) is installed to the rear to an opening in the bottom if the
fuselage. We recommend installing the aerial wire in a piece of Bowden cable
tube in the fuselage.
38
Figure 21
Figure 22