Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting Angle of Air Flow
NOTE : Setting vertical angle of air flow(Remote control)
While the unit is on, use the SWING/DIRECT button on remote control to set the direction (vertical
angle) of airflow. Please refer to the Remote Control Manual for details.
NOTE ON LOUVER ANGLES
Do not set louver at too vertical an angle for long periods of time
●
When using COOL or DRY mode. It would be condense the water
on the louver blade, which will drop on your floor or furnishings.
Setting the louver at too small an angle when using COOL or HEAT
●
mode, can reduce the performance of the AC due to restricted
air flow.
According to the relative standards requirement, please sets the
●
vertical air flow louver to its maximum angle under heating
capacity test.
NOTE
Do not move louver by hand. You can turn o the unit and unplug it for a few seconds to restart
the unit. It will be reset the louver when you try.
Setting horizontal angle of air flow(Manual operation)
The horizontal angle of the airflow must be set
manually. Grip the deflector rod and manually
adjust it to your preferred direction.
For some units, the horizontal angle of the airflow
can be set by remote control. please refer to the
Remote Control Manual.
CAUTION
Do not put your fingers in or near the blowerand suction side of the unit. The
high-speed fan inside the unit may cause injury.
37
Heating
Capacity
Test
Deflector rod
Werbung
