2. Introduction
MANUFACTURER:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new product brings you much enjoyment
and success.
NOTE:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling,
• Failure to comply with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed.
Note:
The operating manual is part of this product.
It includes important instructions for the safe, proper
and economic operation of the product, for avoiding
danger, for minimising repair costs and downtimes and
for increasing the reliability and extending the service
life of the product. In addition to the safety instructions
in this operating manual, you must also observe the
regulations applicable to the operation of the product
in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the device
on to third parties.
3. Device description
1.
Driver's seat
1a.
Screw
1b.
Nut
1c.
Seat contact switch
2.
Catch basket
3.
Mower on/off
46 | GB
www.scheppach.com · service@scheppach.com
4.
Cutting height setting
5.
Battery cover
5a
Battery*
5b
Battery charger*
6.
Rear wheels
7.
Water connection
8.
Mower (protection)
8a.
Mowing blade
9.
Wheels, front
10.
LED lights (depending on model)
11.
Transport bar
12.
Locking brake
13.
Brake/clutch pedal
14.
Speed lever
15.
Steering column
15a. Steering rod
15b. Screw
15c. Nut
15d. Steering connection piece
16.
Steering wheel
16a. Steering wheel cover
16b. Nut
16c. Metal washer
16d. Steering wheel mount
16e. Plastic disc
16f.
Rubber ring
17.
Gear switching
18.
Ignition lock
18a. Ignition key
19.
On/off switch for LED light (depending on model)
20.
Ejector chute
20a. Fastening hooks
20b. Ejector tube (bottom)
20c. Ejector tube flap
20d. Ejector tube mounting bracket
20e. Fastening hooks
21.
Oil tank cover with dipstick
22.
Fuel filler cap
23.
Side discharge
24.
Air filter housing
24a
Air filter
25
Spark plug
25a. Spark plug connector
26.
Fuse 5 A
26a
Holder retainer
27.
Pull starter