Werbung
APPLICATION
Opening the pressure cooker
Push the button for setting the lid on towards the centre of the pressure cooker and move the upper
handle counter-clockwise (1). Open the pressure cooker and remove the lid.
NEVER APPLY INAPPROPRIATE FORCE WHEN OPENING THE PRESSURE COOKER.
Inspecting the valves and the lock
Operating valve
Check whether the silicone operating valve is clear, correctly positioned in the lid of the pressure
cooker and whether it springs (2). If the operating valve is clogged, remove and clean it under
running water. If the valve does not spring or is otherwise damaged, replace it with a new silicone
operating valve.
IMPORTANT NOTICE
Replace the silicone operating valve with a new one after every 50 cooking cycles or at least once
annually. For a spare Silicone valve for pressure cookers ELEMENT, 2 pcs (code 701310), please go to
www.tescoma.com or visit a TESCOMA Retail Centre.
Lock against accidental opening / safety valve
Press on the centre of the safety valve to make sure that it springs (3). If it does not spring, press on
its centre, fl ush it under running water and check that it springs.
Notice: Check whether the nut of the safety valve is tightened well before each use. If the nut is
loose, tighten it.
Steam release valve
Pull the valve to check whether it springs (4). If it does not spring, fl ush it under running water and
check that it springs.
INSPECT THE VALVES AND THE LOCK BEFORE EACH USE. IF THE PROBLEM CANNOT BE RESOLVED USING
THE ABOVE PROCEDURES, DO NOT USE THE PRESSURE COOKER AND CONTACT A TESCOMA SERVICE
CENTRE.
Filling the pressure cooker
NEVER COOK WITHOUT WATER IN THE PRESSURE COOKER – THE MINIMUM AMOUNT OF WATER IS
250 ML.
For safety reasons, the pressure cooker must be fi lled to a maximum of 2/3 vessel capacity. With food
that tends to froth or swell when heated, such as soup, legumes and rice, fi ll the pressure cooker to
a maximum of 1/4 vessel capacity to avoid clogging of the valves (5).
Closing the pressure cooker
Place the lid of the pressure cooker onto the vessel so that the 'pressure cooker closed' mark on the
lid is aligned with the 'pressure cooker closed' mark on the lower handle (6).
Rotate the upper part of the handle clockwise until the two handles are aligned and the button for
removing the lid moves back to the original position (7).
4
Werbung
