Werbung
EtherNet/IP
Id
Attribute
2
Network sta-
tus
3
Ring Supervi-
sor Status
4
Ring Supervi-
sor Config
5
Ring Faults
Count
6
Last Active
Node on Port
1
7
Last Active
Node on Port
2
8
Ring Protocol
Participants
Count
9
Ring protocol
participants
list
10
Active Super-
visor Address
11
Active Super-
visor Prece-
dence
12
Capability
Flags
* Die bedingten Attribute sind für Geräte implementiert, die in der Lage sind,
in einem Ring zu funktionieren.
46
Access
Data type
Rule
Get
USINT
Get*
USINT
Set*
STRUCT of:BOOL
R.S EnableUSINT
R.S Precedence
UDINT
Beacon Interval
UDINT
Beacon TimeoutU-
INT
DLR VLAN ID
Set*
UINT
Get*
STRUCT of:UDINT
Device IPARRY of 6
USINT MAC
Get*
STRUCT of:UDINT
Device IPARRY of 6
USINT MAC
Get*
UINT
Get*
ARRY of:STRUCT
of:UDINT Device
IPARRY of 6
USINTs MAC
Get
STRUCT of:UDINT
Supervisor IPARRY
of 6 USINTs Super-
visor MAC
Get*
USINT
Get
DWORD
4.2 EtherNet/IP-Entity-Parameter
Description
Current status of network.0: normal
1: Ring Fault2: Unexpected Loop
Detection3: Partial Network Fault4:
Rapid Fault/ Restore Cycle
0: Backup1: Active Ring Supervisor2:
Normal Ring Node3: Non-DLR topo-
logy4: Device cannot support the
Beacon Interval or Timeout
Default: FALSE
Default: 0
Default: 400
Default: 1960
Default: 0
Number of ring faults since power up
Last Active node at the end of chain
through port 1 of active ring supervi-
sor during ring fault
Last Active node at the end of chain
through port 2 of active ring supervi-
sor during ring fault
Number of devices in ring protocol
participants list
List of devices participating in ring
protocol.
IP and or/ MAC address of the active
ring supervisor
Precedence value of the active ring
supervisor
Describes the DLR capabilities of the
device
UM IndustProtocol HiOS-2S RSPE
Release 6.1 09/2016
Werbung
Kapitel
