Ethernet-Verbindungsobjekt - Hirschmann Hios-2S Rspe Referenzhandbuch

EtherNet/IP
4.2.3

Ethernet-Verbindungsobjekt

Legen Sie mindestens 1 Instanz für das Gerät fest, z. B. Instanz 1 als CPU-
Ethernet-Schnittstelleninstanz (Class Code 0xf6, F6
Net/IP".
Id Attribute
1 Interface
Speed
2 Interface
Flags
3 Physical
Address
4 Interface
Counters
5 Media Coun-
ters
6 Interface
Control
7 Interface type Get
38
Access Data type
Rule
Get UDINT
Get DWORD
Get ARRAY of 6
USINTs
Get STRUCT of:
MIB II CountersE-
ach UDINT
Get STRUCT of:
Ethernet MIB Coun-
tersEachUDINT
Get/Set STRUCT of:
WORD Control
BitsUINT
Forced Iface Speed
USINT
4.2 EtherNet/IP-Entity-Parameter
, 246) von „Ether-
H
Description
Used interface speed in MBits/s (10,
100, 1000, ...). 0 is used when the
speed has not been determined or is
invalid because of errors.
Interface Status Flags:
Bit 0: Link State (1=Link),
Bit 1: Halfduplex(0)/Fullduplex(1),
Bits 2-4: Autoneg Status
0 Autoneg in Progress,
1 Autoneg failed,
2 failed but Speed detected,
3 Autoneg success,
4 No Autoneg,
Bit 5: manual configuration require
reset (always 0 because not
needed),
Bit 6: hardware error.
MAC address of physical interface.
InOctets, InUcastPackets, InNUcast-
Packets, InDiscards, InErrors, InUnk-
nownProtos, OutOctets,
OutUcastPackets, OutNUcastPa-
ckets, OutDiscards, OutErrors.
Alignment Errors, FCS Errors, Single
Collision, Multiple Collision, SQE Test
Errors, Deferred Transmissions, Late
Collisions, Excessive Collisions, MAC
TX Errors, Carrier Sense Errors,
Frame Too Long, MAC RX Errors.
Control Bits: Autoneg enable/disable
(Bit 0, enable=1)Duplex mode (Bit 1,
full duplex=1), if Autoneg disabled (Bit
0 set to 0).Interface speed in MBits/s:
10,100,..., if Autoneg disabled (Cont-
rol Bit 0 set to 0).
Type of interface:
Value 0: Unknown interface
type,Value 1: The interface is inter-
nal,Value 2: Twisted-pair,Value 3:
Optical fiber.
UM IndustProtocol HiOS-2S RSPE
Release 6.1 09/2016