Sharp VC-H92HM Serviceanleitung Seite 12

replacement, for example).
TOOLS NECESSARY FOR ADJUSTING THE MECHANICAL UNITS
The following tools are required for proper service and satisfactory repair.
[he] fanem | PartNo. fod configuration
JiGACH-A323U
jefe _
\
jf
JiGVHT-063
Tension Gauge (300g) JiGSG0300
c=
Tension Gauge (2.0kg) JiGSG2000 BS
Hex Wrench (0.9mm) JiGHW0009 Fa |
Hex Wrench (1.2mm) JiIGHW0012 jac
Hex Wrench (1.5mm) JiGHW0015 ae |
Alignment Tape (PAL) VROCPSV
These Jigs are used for checking and
adjusting the reel disk height.
This Jig is used for setting the A/C
A/C Head Tilt Adjusting Jig head tilt.
These Jigs are used for checking and
adjusting the torque of take-up and
supply reel disks.
This cassette torque meter is used
for checking and adjusting the
torque of take-up for measuring
tape back tension.
Cassette Torque Meter
There are two gauges usicd for the
tension measurements, 320 g and
2.0kg.
These Jigs are used for lowening or
tightening special hexayon type
screws.
These tapes are especially mised for
electrical fine adjustment.
f
Hi-Fi Alignment Tape (PAL) VROCBFFS Cc
JiGADP003
This Jig is used with the tension
gauge. Rotary transforner clear-
ance adjusting jig.
Tension Gauge Adapter
11