Werbung
- stop the engine and remove the key.
°
Disengage drive to attachments, stop the engine, and
disconnect the spark plug wire(s) or remove the ignition
key
before cleaning blockages or unclogging chute.
before checking, cleaning or working on the lawn-
mower.
i
- after striking a foreign object. Inspect the lawnmower
for damage and make repairs before restarting and
operating the equipment.
- ifthe machine starts to vibrate abnormally (check
immediately)
e
Disengage drive to attachments when transporting or
not in use.
e
Stop the engine and disengage drive to attachment
- before refueling.
- before removing the grass catcher.
- before making height adjustment unless adjustment
can be made from the operator's position.
°
Reduce the throttle setting during engine run-out and, if
the engine is proveded with a shut-off valve, turn the
fuel off at the conclusion of mowing.
IV. Maintenance and storage
e
Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
e
Never store the equipment with petrol in the tank inside
a building where fumes may reach an open flame or
spark.
e
Allow the engine to cool before storing in any enclosure.
e
To reduce the fire hazard, keep the engine, silencer,
battery compartment and petrol storage area free of
grass, leaves, or excessive grease.
e
Check the grass catcher frequently for wear or deterio-
ration.
°
Repiace worn or damaged parts for safety.
ə
If the fuel tank has to be drained, this should be done
outdoors.
°
On multi-bladed machines, take care as rotating one
blade can cause other blades to rotate.
e
When machine is to be parked, stored or left
unattended, lower the cutting means unless a positive
mechanical lock is used.
A CAUTION!
Always disconnect spark plug wire and place wire
where it cannot contact spark plug in order to
prevent accidental starting when setting up, trans-
porting, adjusting or making repairs.
Werbung
