Safety Information For Dismantling And Assembly - Wellsystem Relax Montageanweisung

2

Safety information for dismantling and assembly

6/68 1009892-04
Safety information for dismantling and assembly
DANGER!
Electricity throughout entire device!
Assembly and connection to the mains electrical supply
must comply with the national regulations.
wellsystem MEDICAL / MEDICAL_PLUS is subject to
special preventive measures with regard to electromag-
netic compatibility and must be installed and commis-
sioned in compliance with the EMC instructions in the
Appendix; see page 63.
Assembly, installation, upgrading and servicing the de-
vice is only to be carried out by personnel who have
been specially trained by JK-Global Service.
– The device must only be set up and used in closed
rooms.
– Safety equipment (e.g. switches) and safety instruc-
tions must not be removed or deactivated as this
might impair a safe operation of the device!
– You must always abide by the danger and safety
instructions warnings attached to the device, even
during assembly and disassembly (see page 60).
– The unit is only to be handed over to the operator in
a flawless condition!
– The massage unit must not be used if it has not
been filled!
– A water cooling system must be connected to the
device if it is to be used for more than 1 hour per
day at maximum pressure. The pressure hoses
must not be removed.
– The device may only be operated with the pressure
hoses included in the scope of delivery.
– A water shut-off valve must be used.
– The assembly is only to be carried out in the se-
quence stipulated in these assembly instructions!
– wellsystem MEDICAL / MEDICAL_PLUS:
The unit must be disconnected from the power sup-
ply before any assembly and disassembly work is
carried out on the electrical units (see page 13). Ex-
ceptions are permissible only for function tests!
– wellsystem RELAX / RELAX_PLUS:
Before beginning work, pull out the mains plug or
disconnect all live lines.
10/2017