Safety Information For Dismantling And Assembly - Wellsystem MEDWAVE Montageanweisung

2

Safety information for dismantling and assembly

6/90 1020049-00E
Safety information for dismantling and assembly
DANGER!
Electricity throughout entire device!
Assembly and connection to the mains electrical supply
must comply with the national regulations.
wellsystem MEDWAVE/MEDWAVE TOUCH is subject
to special preventive measures with regard to electro-
magnetic compatibility and must be installed and com-
missioned in compliance with the EMC instructions in
the Appendix; see page 87.
Assembly, installation, upgrading and servicing the de-
vice is only to be carried out by personnel who have
been specially trained by JK-Global Service.
– The device must only be set up and used in closed
rooms.
– Safety equipment (e.g. switches) and safety instruc-
tions must not be removed or deactivated as this
might impair a safe operation of the device!
– You must always abide by the danger and safety
instructions warnings attached to the device, even
during assembly and disassembly (see page 84).
– The unit is only to be handed over to the operator in
a flawless condition!
– The massage unit must not be used if it has not
been filled!
– A water cooling system must be connected to the
device if it is to be used for more than 1 hour per
day at maximum pressure. The pressure hoses
must not be removed.
– The device may only be operated with the pressure
hoses included in the scope of delivery.
– A water shut-off valve must be used.
– The assembly is only to be carried out in the se-
quence stipulated in these assembly instructions!
– wellsystem MEDWAVE/MEDWAVE TOUCH:
The unit must be disconnected from the power sup-
ply before any assembly and disassembly work is
carried out on the electrical units (see page 14). Ex-
ceptions are permissible only for function tests!
12/2021