Use this page to enter the modbus address to be associated with the VMF-RCC system and the serial communication baud rate between panel and supervisory control (BMS,
Aerweb, VMF-Monitoring).
To enter the data editing mode, press the
key. This status is highlighted when no parameter is displayed. To change the value, act on the increase (
) and decrease (
) keys. The data is confirmed by pressing the enter (
) key, while the effective memorisation in EEPROM is highlighted by the disappearance of the denied display.
Press the
key for the system to display the menu page.
Using the Page Up
and Page Down
keys, scroll the pages contained in the sub-menu.
A B GND
Expansion board for supervision serial line. The VMF-RCC control is slave to the supervision serial line.
The modbus registers in the VMF-RCC panel are described in the Modbus_slave_log.xls file.