Climate Page For Generator Set Point; Control Type Page - Aermec Vmf-Rcc Zubehörhandbuch

CLIMATE PAGE FOR GENERATOR SET POINT

The compensation curve of the water output set point of the chiller can be set on this page, according to the external air temperature.
Level: user.
1
1. Reference season of the compensation curve
2. TAE1, TUA1
3. TAE2, TUA2
4. Enabling compensation
5. Page change to select the season
Example of compensation curve according to the external air temperature
TWout [°C]
Tua2
Tua1
Tae1
The chiller set can be compensated according to the external air temperature only if the VMF algorithm is not enabled and no MultiControl is available.
To change the value of compensation curve points (Tae1, Tua1) and (Tae2, Tua2) select keys increase (
quent datum press key enter ( ), while the effective memorisation in eeprom is highlighted by the disappearance of the denied display. Points of the curve are correctly
confirmed if Tae1 < Tae2, otherwise the phrase
Keys and are used to change the display of the compensation curve inherent to the operation season (summer or winter).
The icon / indicates the enabling/disabling of the compensation of the water output set of the chiller, according to the external air temperature.
Press the
key for the system to display the menu page.
Using the Page Up and Page Down

CONTROL TYPE PAGE

Use this page to select the type of control for the chiller/heat pump (MODU_CONTROL, PCO) in the system, or to disable it (NO CHILLER).
Level: super user.
23/03 – VMF-RCC_UN50_01
4
Tae2
TAext [°C]
will be temporarily displayed.
keys, scroll the pages contained in the sub-menu.
5
TWout [°C]
Tua1
Tua2
Tae1
) and decrease (
2
3
Tae2
TAext [°C]
). To confirm the value and pass to the subse-
61