Main Page - Aermec Vmf-Rcc Zubehörhandbuch

3

MAIN PAGE

2
1
5
7
The main page uses icons to supply the user with different information regarding system functions. Below please find a description of the signals present.
— ON/OFF: if the
icon is present, the whole system (VMF-RCC panel, chiller, fan coils, DHW) is enabled to operate.
— SEASON: indicates the system functioning mode (
— FANCOILS: this section shows the fan coil status; the
— POWER: the bar graph indicates the cooling capacity percentage that is instantaneously requested by the fan coils to meet load requirements. If there are no fan coils in
the system, the graph will not be shown.
— TEMPERATURE: indicates the temperature read using the probe present on the panel.
— ALARM: the appearance of an alarm is highlighted by the presence of a bell that rings
ory has not be consulted in order to identify the origin. The reading of the alarms log makes the state of the bell change instantly
anomaly that caused it to appear has been restored.
— DATE TIME: day of the week, dd/m/yy, h:min:sec.
— TIME PERIODS: the
icon appears if the user sets an hourly program for at least one fan coil (area) or for the DHW.
Only during display of the main page is the On/Off (
is possible to access the menu selection screen, by pressing at least one of the
Back-lighting:
The display mounted in the VMF-RCC panel has back-lighting that is normally off. To activate it, press the relevant keys. It will remain on throughout the panel use. Switch-off
takes place after 30 seconds of inactivity.
The LCD lighting is on also with an alarm event in order to emphasize it and draw the user's attention. The back-lighting switches off after 30 seconds of inactivity also in this
case. The alarm remains indicated by a flashing red LED present at the side of the display.
23/03 – VMF-RCC_UN50_01
winter, summer).
icon will appear if even just one fan coil is functioning.
) key active. The system state change takes place if the control is pressed for at least 5 seconds. From the main page it
, ,
3
4
6
8
. This indication highlights that the alarm has just occurred and the alarms mem-
, keys.
1 ON/OFF
2 Season
3 Requested by Fancoil/MZC
4 Capacity
5 Temperature
6 Alarm
7 Date and time
8 Temp. timer
. The icon disappears only after the
41