Werbung
DE-BINDING
7
DE-BINDING
8
DE-BINDING
7
Note!
When de-binding 28 mm and 32 mm, channels it is easier to remove
Note!
Note!
the extended back support.
When de-binding 28 mm and 32 mm, channels it is easier to remove
When de-binding 28 mm and 32 mm channels it is easier to remove
the extended back support.
the extended back support.
8. Make the changes to the document/presentation and rebind.
9. Cover can be re-used two or three times.
8. Make the changes to the document/presentation and rebind.
8. Make the changes to the document/presentation and rebind.
9. Cover can be re-used two or three times.
9. Cover can be re-used two or three times.
DE-BINDING
DE-BINDING
DE-BINDING
back cover
back cover
back cover
1. Place the de-bind wedge in the book 4 or 5 pages
Before de-binding remove the adjustable side stop (9). Move the
clamping lever to the left.
from the back cover, flat side towards the front of the book
1. Place the de-bind wedge in the book 4 or 5 pages
1.De-binding channels up to 16mm, put the de-bind wedge in the
and sharp edge towards the spine.
from the back cover, flat side towards the front of the book
book 4 or 5 pages from the back cover, flat side towards the front,
and sharp edge towards the spine.
2. To de-bind documents thicker than 16 mm.
sharp edge towards the spine. De-binding channels 1.5 mm and 3
• Place the documents on the equipment front down
mm, use the de-binding adapter (11). Put the de-binding adapter
2. To de-bind documents thicker than 16 mm.
• Open the book and put the wedge in level
(11) on the channels, small slot is for 1.5 mm, bigger for 3 mm.
• Place the documents on the equipment front down
with the de-binding hooks
2. De-bind documents thicker than 16 mm.
• Open the book and put the wedge in level
• Place the documents on the equipment front cover down
with the de-binding hooks
• Open the book and put the wedge in level with the de-binding
hooks.
3. Fit the ends of the wedge in the de-binding hooks.
4. Close the clamping lever until the channel is flat
3. Fit the ends of the wedge in the de-binding hooks.
3. Fit the ends of the wedge in the de-binding hooks.
against the binding plate and you feel a resistance.
4. Close the clamping lever until the channel is flat
4. Push the handle (1) down and up until the document is de-
5. Holding the clamping lever with one hand and moving
against the binding plate and you feel a resistance.
bound.
the binding handle forward 4 or 5 times until covers are loose.
5. Holding the clamping lever with one hand and moving
5. Pull the handle (1) to the open position and move the clamping
6. Move the binding handle to the open position.
the binding handle forward 4 or 5 times until covers are loose.
lever (2) to the left.
7. Move the clamping lever fully to the left.
6. Move the binding handle to the open position.
6. Remove covers and pages together with the wedge.
Remove covers and pages together with the wedge.
7. Move the clamping lever fully to the left.
7. Open and remove the wedge carefully from the documents.
Open and remove the wedge carefully from the documents.
Remove covers and pages together with the wedge.
Open and remove the wedge carefully from the documents.
6
Werbung
