DAB MCE-55/P Installations- Und Wartungsanleitungen Seite 107

6.6.14.1 O1: Output 1 function setting
Output 1 notifies of an active alarm (i.e. that there is a system block). The output enables use of a normally
closed or normally open voltage-free contact.
Parameter O1 is associated with the values and functions specified in Table 26.
6.6.14.2 O2: Output 2 function setting
Output 2 notifies of electric pump running status (pump on/off). The output enables use of a normally closed
or normally open voltage-free contact.
Parameter O2 is associated with the values and functions specified in Table 26.
Output
Activation
configuration
conditions
No function
0
associated
No function
1
associated
Presence of blocking
2
errors
Presence of blocking
3
errors
Table 26: Output configuration
6.6.15 RF: Fault and warning log reset
To clear the fault and warning log, press and hold the buttons + and – simultaneously for at least 2 seconds.
The number of faults present in the log (max. 64) are summarised below the RF symbol.
The log can be viewed from the MONITOR menu on the FF page.
ENGLISH
Configuration of functions associated with outputs
OUT1
Output contact
status
NO contact always open,
NC contact always closed
NO contact always
closed, NC contact always
open
In event of blocking errors
NO contact closes and
NC contact opens
In event of blocking errors
NO contact opens and NC
contact closes
Activation
conditions
No function
associated
No function
associated
Activation of output in
event of blocking
errors
Activation of output in
event of blocking
errors
103
OUT2
Output contact
status
NO contact always open,
NC contact always closed
NO contact always
closed, NC contact always
open
When the pump is
running, the NO contact
closes and the NC contact
opens
When the pump is
running, the NO contact
opens and the NC contact
closes