DAB MCE-55/P Installations- Und Wartungsanleitungen Seite 83

4.3 Multi inverter operating parameters
The parameters displayed on the menu, in a multi-inverter configuration, can be classed as follows:
Read-only parameters
Local parameters
Multi inverter system configuration parameters
Sensitive parameters
o
Parameters with optional alignment
o
4.3.1 Parameters related to multi inverter systems
4.3.1.1 Local parameters
These are parameters that can differ from one inverter to another and in some cases actually need to be
different. For these parameters, automatic alignment of inverter configuration is not admitted. In the case of
manual assignment of addresses, these must all be different.
List of local parameters for inverters:
CT Contrast
FP Test frequency in manual mode
RT Direction of rotation
AD Address
IC Reserve configuration
RF Fault and warning reset
4.3.1.2 Sensitive parameters
These are parameters that must be aligned on the entire series for control purposes.
List of sensitive parameters:
SP Setpoint pressure
P1 Input 1 auxiliary pressure
P2 Input 2 auxiliary pressure
P3 Input 3 auxiliary pressure
P4 Input 4 auxiliary pressure
RP Pressure drop for restart
FI Flow sensor
FK K factor
FD Pipe diameter
FZ Zero flow frequency
FT Min. flow threshold
MP Minimum pressure pump stop due to water failure
ET Exchange time
NA Number of active inverters
NC Number of simultaneous inverters
CF Carrier frequency
TB Dry run time
T1 Shutdown time after low pressure signal
T2 Shutdown time
GI Integral gain
GP Proportional gain
I1 Input 1 setting
I2 Input 2 setting
I3 Input 3 setting
I4 Input 4 setting
OD Type of system
PR Pressure sensor
ENGLISH
in turn divided as
79