Helios easyControls FK82219 Bedienungsanleitung Seite 39

Operating instructions
NOTE
Comfort controller KWL-BEC
The following settings are required when the KWL unit is integrated in a computer network or
directly connected to a computer. The settings are without function for network-independent
operation.
DHCP: Options: Automatic IP address assignment via DHCP
„Yes" (Image left) or „No"
IP address: Display depends on DHCP settings (see above)
„Off" Enter the desired IP address
„On" Displays the assigned IP address (Image left)
Gateway: Display depends on DHCP settings
„Off" Enter the desired gateway
„On" Displays the assigned gateway (Image left)
Subnet mask: Display depends on DHCP settings
„Off" Enter the desired Subnet mask 255.---.---.---
„On" Displays the assigned Subnet mask (Image left)
Action: When checkbox „Yes" is activated, all operation-critical parameters and
Data
synchronisation measured values are sent to the Helios portal server. You can access your KWL
with ventilation
easyControls www.easycontrols.net when you are on the go. Further evaluations are also
portal: possible, such as temperature profiles.
Action: When checkbox „Yes" is activated, the system will check online for new
Automatic firmware
updates: firmware on a daily basis. If new firmware is found, it will be automatically
updated.
The charging process begins between 23:00 and 05:00 hrs.
Recommendation! Enable automatic firmware updates!
System booting: Once the initial start-up is complete, the controller KWL-BEC or the system
will reboot.
5
unit and change settings
GB
via the Helios web portal