Herunterladen Diese Seite drucken

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operating instructions
GB
Comfort controller KWL-BEC
Pre-heater
The pre-heater can be activated or deactivated depending on the installation.
ATTENTION: The pre-heater is factory-activated and must be deactivated during the initial
start-up if an internal or external pre-heater is not installed.
Supply/extract air
Setting the fan stage when the ventilation unit is set to either only supply air mode or only extract air
mode via the external contact. This configuration option is only possible if the configuration 1 = DIBT
is set in the unit configuration!
– Fan stage supply air
Factory setting: Fan stage 2
Safety functions (e.g. frost protection) override this setting.
– Fan stage extract air
Factory setting: Fan stage 2
Safety functions (e.g. frost protection) override this setting.
Unit configuration
All specific unit settings can be found under menu item „Unit configuration", such as configuration,
pre-heater type, auxiliary heater type, heat exchanger type, ext. contact, fault output.

– Configuration

– Config 1 = DiBt (takes the control technology requirements of DIBT into account)
– Config 2 = PHI (takes the control technology requirements of PHI into account)
If the installed ventilation unit is certified by the Passivhaus Institute, this will be taken into account
in the factory settings.
ATTENTION: Only the control technology requirements are changed by switching from DIBT
to PHI. Thus, the ventilation unit is not automatically PHI-certified!!
– Pre-heater
The following pre-heater types are available to order as unit-dependent accessories.
– Pre-heater electr. intern (Basis) (KWL EC 200/300/500 W and KWL EC 220/340 D)
– Pre-heater electr. (230V/400V) via KWL-EM (required)
– Pre-heater SEWT using KWL-EM (required)
– Pre-heater LEWT using KWL-EM (required)
– Auxiliary heater type
The following auxiliary heater types are available to order as unit-dependent accessories.
– Auxiliary heater electr. (230V/400V) via KWL-EM (required)
– Auxiliary heater hot water auxiliary heating coil via KWL-EM (required)
20

Werbung

loading