Appearance Of The Cursor; Menu Structure Of The Smartline Pump 1000; Selecting Menus - Knauer Smartline Pump 1000 Handbuch

10

Appearance of the Cursor

Fig. 6

Menu Structure of the Smartline Pump 1000

LINK Menu
Link
View
VIEW Menu
Fig. 7
SOP 1
backflushing, follow
"Automatic piston Backflushing" on page 20.
The green arrow keys on the foil key touchpad can be used for
positioning the blinking cursor on any field of the menu screen.
The cursor appears as an underscore character while entering values
(see Fig. 6, below). Refer to SOP 2 "Entering Data" on page 11 for
guidelines on how to use the numeric keypad for data input (item {2.3} in
Fig. 3).
Blinking Cursor
The display of the Smartline Pump 1000 has one main menu screen
which shows the status information of the instrument. From the main
menu screen, four additional menu screens are accessible.
By default, the Smartline Pump 1000 main menu screen displays the
parameters of the first program line of the currently active program.
An example of the main menu screen is shown below in Fig. 7 "Menu
Structure of the Smartline Pump 1000".
Load Edit Prog Flow
Prog Clear 0 [ml/min]
01 -- 001.0
OFF 000.00
Hold 0 Time
Run 1 [min]
Menu structure of the Smartline Pump 1000

Selecting Menus

This SOP applies to the Smartline Pump 1000 Firmware Version 1.0X or
higher. Use this SOP to select menu screens for viewing and setting
pump parameters.
The four menus of the Smartline Pump 1000 can be accessed with the
following procedure:
1. Place the cursor in a field in one of the four corners of the main
screen, e.g. on OFF in the lower left corner of the main menu.
2. Depending on the selected corner, press the corresponding left or
right arrow key for longer than 2 seconds. In the example above,
selection of the
3. Select the rhombus
want to access additional pages of the selected menu. You can
access all menu pages by scrolling using the
4. Select the rhombus
Control of the Smartline Pump 1000
the instructions
Cursor during data input
Pressure Events
[0.1 Mpa] off 0 on 1
000 0 0 0 0 0 0 0 0
%A %B %C %D
key will activate the VIEW Menu on the display.
in the lower left corner of the display if you
and use or to return to the main screen.
given in the section
SETUP Menu
2
Setup
GLP
GLP Menu
or arrow keys.