Setup Of The Hplc Pump K-120; Delivery Content; Front View Of The Hplc Pump K-120 - Knauer K-120 Handbuch

6

Setup of the HPLC pump K-120

Delivery Content

Front view of the HPLC pump K-120

1
2.1
2.2
2.3
Fig. 1 shows the front view of the HPLC pump K -120
Unpack the instrument and check pump and accessories for any
damage due to shipping. Place any claims referring to damage to
the transportation company responsible for shipping.
Please check that the HPLC pump K–120 is complete, using the
section Packing list. Please contact our service department, if
something is missing, in spite of our thorough control procedures.
1 Pump, including pump head 10 or 50ml, and
accessories
1 Power supply unit 24V/50W
1 Power supply cable
1 Set Tools
1 RS-232 cable
1 Plug strip with connectors
1,5 m Flat cable
1 Set Piston backflushing
1 PTFE eluent filter
1 Set Inlet screw with fittings
1 Operation Manual
1 Guarantee Statement KNAUER
Please fill in the registration card for guarantee and return it
immediately. Please remove the transparent, protective foil from
pump outlet and display.
Various connections, three keys, and a LED display are located on
the front panel. The flow rate display 1 indicates two digits. The
range <1ml is shown with both digits behind the decimal point
(e.g.: .05), the range ≥ 1ml and ≤ 10ml is shown like 5.5 and the
range ≥ 10ml in integer numbers.
The assembling of the pump head is described in the chapter
"Connection of the pump head" on page 7.
Setup of the HPLC pump K-120
3
Flow rate display
1
Keys
2
Flow rate up
2.1
Flow rate down
2.2
START/STOP
2.3
Pump head
3