Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
24
SOP 15
SOP 16
During program execution the current solvent composition can be
observed in the display fields % A and % B. At the end of the
program the pump returns to the first line of the active program and
continues pumping and the display will indicate ON in the lower left
corner.
Modifying and Deleting Programs
This SOP applies to the Smartline Pump 1000 Firmware Version 1.0X or
higher. Use this SOP for modifying and deleting programs.
1.
Enter the number of the program to be modified in the EDIT PROG
field.
2.
Move the cursor to the value you want to modify.
3.
Enter the new values to overwrite the old values. Incorrect entries
can also be corrected in the same way.
4.
Confirm your entries by pressing any arrow key.
Delete program lines as follows:
5.
Enter 0 (zero) in the TIME FIELD and press any arrow key. The
message Delete this line? Confirm by cursor appears. Pressing
any arrow key deletes the program line. Pressing any numeric key
or none at all for several seconds aborts the process of deletion.
Deletion of programs or program links:
6.
Select field EDIT PROG.
7.
Enter 0 in the field EDIT PROG.
8.
Confirm deletion according to step 5 of this SOP.
Using a Wake-Up Program
This SOP applies to the Smartline Pump 1000 Firmware Version 1.0X or
higher.
The Smartline Pump 1000 can execute a program at a preset time.
Make sure that the date and time of the Smartline Pump 1000 are set up
properly according to section "The SETUP Menu" on page 12.
A Wake-Up Program is created as follows:
1.
Enter the program number 30 (specifically reserved for this
purpose) in the EDIT PROG field.
2.
Enter the desired program for Wake-Up in the P: field and the
desired time and date in the fields at: and on:.
3.
Load reserved program 30.
4.
If necessary, switch the pump to OFF with the START/STOP key.
While waiting for the programmed time, the display will blink. The pump
will start program execution with the selected program at the preset time
and switch into RUN mode.
Programming the Smartline Pump 1000
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
