Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EGEA TECH
8.12
COMMISSIONING
To commission the device, perform the following operations.
8.12.1 Preliminary checks
Check that the device has been
connected to the ground cable.
OBLIGATION
Check that the line voltage cor-
responds to that indicated on the
device plate.
ATTENTION
Check that the device is free from
tools or utensils of various kinds.
VISUAL IN-
If present, remove them.
SPECTION
8.12.2 General cleaning
•
Do not pour or spray water on
the product.
•
Do not clean the surfaces with
PROHIBITION
easily flammable substances
(for example: alcohol or paint
thinners).
Clean only the external surface
using a soft and dry cloth.
MANUAL
CLEANING
8.12.3 Commissioning of the plant
• Fill the tank completely via the inlet faucet and check that
there are no water leaks from gaskets and connections.
• Do not exceed the max. permissible pressure indicated in the
"general technical data" section.
• Check the water circuit safety devices.
• Plug the unit into the power outlet.
• When the plug is inserted, the unit is OFF.
To turn on the unit, refer to paragraph "3.5.1 Power on" on
page 146
In case of a sudden power outage, when restored the equipment
will restart from the operating mode prior to the interruption.
200 LT - 260 LT -200 LT-S - 260 LT-S
cod. 3540000410 - Rev. 03 - 09/2023
8.12.4 Query, editing operating parameters
This
equipment
has
ing
and
modifying
For details, refer to chapter "3. USE OF THE WATER HEATER"
on page 144.
NB!: Use of the password is reserved for qual-
ified personnel; any consequences due to
incorrect parameter settings will be the sole
responsibility of the customer. Therefore,
any interventions requested by the customer
from an authorised technical assistance cen-
tre FERROLI during the standard warranty
period, for product problems due to incorrect
settings of password-protected parameters,
will not be covered by the standard warranty.
distinct
menus
for
the
operating
parameters.
EN
consult-
191
Werbung
