Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EGEA TECH
3.2.1 General and control panel cleaning
Periodicity:
MONTHLY
(or in conditions of
USER
evident dirt)
Do not pour or spray water on the
product.
Do not clean the surfaces with
PROHIBITION
easily flammable substances (for
example: alcohol or paint thin-
ners).
Clean only the external surface
and the control panel using a
soft, dry cloth.
MANUAL
CLEANING
3.2.2 Operating anomalies / failures
In case of operating anomalies, possible failures or replace-
ment of parts due to wear/damage, the user must:
• switch off the water heater as indicated in the section
"Switching off" in paragraph 3.5 and disconnect the power
cord plug from the socket.
• Contact an expert technician or the technical assistance
service.
3.3
MAINTENANCE TO BE CARRIED OUT BY THE
EXPERT TECHNICIAN
Any
equipment must be performed
by qualified personnel. Exclu-
sively for interventions on the
refrigeration circuit, including
disposal, the personnel must
be equipped with a suitable re-
EXPERT TECHNICIAN
frigeration technician's licen-
se aimed at the knowledge and
management of systems con-
taining gases of the HFC type.
200 LT - 260 LT -200 LT-S - 260 LT-S
Equipment to be
used
Soft and dry cloth
intervention
on
cod. 3540000410 - Rev. 03 - 09/2023
CHECK OF THE DEVICE
USER
To ensure the functionality and efficiency of the device, it must
be subjected to regular checks.
• Refer to chapter 10.
TROUBLESHOOTING / REPLACEMENT / MAINTENANCE
USER
Before carrying out any type of intervention on the device, the
personnel in charge of maintenance must refer to what is re-
ported in this manual in the following chapters and in particular
to consult chapter "10. REQUIREMENTS FOR THE OPERA-
TION, SERVICE AND INSTALLATION" on page 194.
ATTENTION
the
ATTENTION
EXPERT TECHNICIAN
/ MANUFACTURER'S
TECHNICAL
ASSISTANCE
EXPERT TECHNICIAN
/ MANUFACTURER'S
TECHNICAL
ASSISTANCE
The manufacturer cannot be held
responsible
for
carried out by non-expert and
non-qualified personnel.
DO NOT TAMPER WITH THE
POWER CORD.
If the power supply cable is dam-
aged, it must be replaced by the
manufacturer or the technical as-
sistance service or in any case
by a person with similar qualifi-
cations, in order to prevent any
risk.
EN
Periodicity:
YEARLY
Periodicity:
IN CASE OF
ANOMALY OR
FAULTS.
interventions
145
Werbung
