Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.12
FAULTS/PROTECTION
This device has a self-diagnosis system that covers some pos-
sible faults or protections from anomalous operating conditions
through: detection, signalling and adoption of an emergency
procedure until resolution of the fault.
Fault/Protection
No communication with the display
Tank bottom probe failure
Tank top probe fault
Coil probe fault
Inlet air probe failure
Evaporator inlet probe failure
Evaporator outlet probe failure
Compressor delivery probe failure
Solar collector probe failure
High pressure alarm
Refrigerant temperature not suitable for
heat pump operation. (With the alarm acti-
ve, the water is heated only with the electric
heater).
Air temperature not suitable for heat pump
operation. (With the alarm active, the water
is heated only with the electric heater).
EEPROM error
Cascade alarm, displayed only on master
(no communication with one of the slaves)
Cascade alarm, displayed only on master
(presence of an alarm on one of the slaves)
Cascade alarm, displayed only on slave (no
communication with master)
Legionella cycle not completed
Failure of both tank sensors
NOTE
* With active alarm, and unit in ECO mode, water heating, based on the
set value of parameter H01:
- takes place only with electrical heater (H01 = 1)
- is inactive (H01 = 0)
EN
164
EGEA TECH
Error
Display indi-
code
cation
E00
+ E00
E01
+ E01
E02
+ E02
E03
+ E03
E04
+ E04
E05
+ E05
E06
+ E06
E07
+ E07
E08
+ E08
E09 *
+ E01
E10 *
+ E10
E11 *
+ E11
E60÷65
+ E60÷65
E70
+ E70
E71
+ E71
E72
+ E72
E80
+ E80
E99
+ E99
cod. 3540000410 - Rev. 03 - 09/2023
200 LT - 260 LT -200 LT-S - 260 LT-S
If one or more of the above
faults occur, contact the
manufacturer's technical as-
EXPERT TECHNICIAN
sistance, indicating the error
/ MANUFACTURER'S
code shown on the display.
TECHNICAL
ASSISTANCE
Werbung
