Safety Instructions And Warnings Regarding Storage Of The Via Go; Safety Instructions And Warnings For The Charger - Alber via GO V24 Gebrauchsanweisung

4.4 Safety instructions and warnings regarding storage of the via GO

• Do not expose the via GO to moisture of any kind (water, rain water, snow, etc.).
• Charge the via GO prior to storage and check their charge status every 3 months.
• Store the via GO in a cool and dry location where it is safe from damage and unauthorised access.
• Before shipping or transporting a damaged via GO, consult your specialist dealer or the Alber Service Centre.
• The via GO must be inspected if it is damaged or defective. Please contact your specialist dealer and clarify the further course of action
regarding returns and repairs. The defective/damaged via GO must not be used further or opened under any circumstances.
4.5 Safety instructions and precautions on how to transport and ship the via GO
Lithium-ion cells are used for the via GO's built-in battery. Transport and shipping of the via GO are therefore subject to all applicable
statutory regulations, which must be strictly observed. For example, a defective device must never be transported by plane or carried as
luggage.
As transport regulations may change annually, we strongly recommend that you consult your travel operator, airline or shipping line before
you set out on your trip in order to learn about the current applicable regulations.
Our transport certificate may be helpful in this regard. You can obtain this certificate by calling the Alber Service Centre (tel: 0800 9096
250) or by downloading it at www.alber.de.
If your via GO is defective, please take it personally to your specialist dealer or to an Alber representative, as postal shipments and ship-
ping via other carriers is also strictly regulated with regard to lithium-ion batteries. We do again recommend that you contact your special-
ist dealer or an Alber representative.
Discuss transport with your specialist dealer or an Alber representative prior to shipping

4.6 Safety instructions and warnings for the charger

Before starting the charging process, read and observe all instructions and warnings included with the charger, as
well as the warnings and safety instructions below.
• Only use the charger supplied by Alber to charge the via GO. The charging process will end automatically as soon as the battery is fully
charged. As such, overcharging is impossible.
• Do not use the charger to charge any battery other than the battery of the via GO.
• If the charging process is complete, disconnect the charger from the mains socket first and then disconnect it from the via GO.
• Never use a charger that is not supplied by Alber.
• Do not expose the charger to moisture of any kind (water, rain water, snow, etc.) during charging.
• Be aware of condensation. If the charger is brought from a cold area into a warm room, condensation may occur on and in the device.
In this case, refrain from using the charger until all the condensation has evaporated. This can take several hours.
• Never carry out the charging process in rooms where moisture may affect the charger.
• Never carry the charger by its power cable or the charger cables.
• Never tug at the power cable to disconnect the charger from the mains socket.
• Never subject the cable or plug to any pressure. Overstretching or bending the cables, pinching a cable between a wall and a window
frame or placing heavy objects on a cable or a plug could result in electric shock or fire.
• Lay the power cable and the charger cable in such a way that nobody can step on it or trip over it and in such a way that cable and
charger are protected against any other harmful effects or stress.
• Do not operate the charger if the power cable, the charger cable or the plugs attached to the cables are damaged. Damaged parts must
be replaced immediately by a specialist dealer that has been authorised by Alber.
• Do not use or disassemble the charger if it has received a hard blow or was dropped or damaged in some other way. Take the damaged
charger to a specialist dealer, authorised by Alber, for repair.
• The charger must not be used by young children.
• The charger is designed to operate only with mains alternating voltage of 100 V to 240 V.
• Never attempt to dismantle or modify the charger.
• Do not cover the charger during the charging process or place any objects on top of the device.
• Position the charger securely on a level surface.
15