Temperature Indicator; Safety Instructions And Warnings For The Via Go And The Built-In Battery - Alber via GO V24 Gebrauchsanweisung

The batteries may only be charged in a dry room at temperatures of between 0° and 40 °C.
Observe the instructions in the operating manual included with the charger.
Observe the other instructions regarding the battery in the subsequent chapters of this operating manual.

4.2 Temperature indicator

Operating temperature
If the permissible temperature range is exceeded or undershot during operation of the via GO (ambient temperature range approx. -25 °C to
+50 °C), the via GO will switch itself off automatically. LEDs [14a], [14c] and [14e] flash on the control unit. For details, see also chapter
3.
14
Charging temperature
If the permissible temperature range (0° to maximum 40 °C) is exceeded or undershot when charging the battery, the charging process will
be aborted automatically. LEDs [14a], [14c] and [14e] flash on the control unit. For details, see also chapter 3.

4.3 Safety instructions and warnings for the via GO and the built-in battery

Before starting the charging process, read and observe all instructions and warnings included with the charger, as
well as the warnings and safety instructions below.
• In the event of repairs, only the battery supplied by Alber may be used for operation of the via GO. Other types of batteries could burst
and cause injuries or material damage. The repairs may only be performed by an authorised specialist dealer.
• Never charge the via GO in the presence or vicinity of flammable liquids or gases.
• Keep the via GO away from fire.
• Do not expose the via GO to moisture of any kind (water, rain water, snow, etc.) during charging.
• Never carry out the charging process in rooms where moisture could affect the via GO.
• In the (unlikely) event of the battery overheating or catching on fire, you must ensure that the via GO does not come into contact with
water or other liquids. The only suitable extinguishing agent that is recommended by the cell manufacturers is sand.
• Never charge the via GO at temperatures below 0 °C or above 40 °C. If you attempt to carry out the charging process outside of this
temperature range, the battery's automatic control element will abort the charging process automatically.
• Your via GO consumes energy each time you use it. For this reason, you should never run down the battery completely, as doing so can
damage the battery in the long term. We recommend recharging the battery immediately after every use if possible.
• Only use the Alber charger included in the delivery to charge the via GO. The charging process will end automatically as soon as the bat-
tery is fully charged. As such, overcharging is impossible.
• If the charging process is complete, disconnect the charger from the mains socket first and then disconnect it from the via GO.
• Do not immerse the via GO in water. Doing so could lead to irreversible damage.
• The service life of the battery depends on the via GO's storage location, among other factors. As such, never leave the via GO in hot
locations for prolonged periods of time. In particular, use the boot of a car parked in the sun only for transport – never as a storage
location.