Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
2.4 Attaching the control unit
A mount [16] has been attached to the right push handle of the wheelchair. The control
unit is inserted into this mount.
• Make sure that the control unit is not switched on.
• There is an opening on the underside of the control unit [15]. Hold the control unit at
an angle of approx. 45° and insert it in the slot on the right-hand side of the mount.
• Then swing the control unit down until it is in full contact with the mount [16].
• The control unit can now be used.
2.5 Removing the control unit
• Make sure that the control unit is not switched on.
• Lightly press against the underside of the control unit from below, tilt it to the right,
and then completely remove it from the mount [16].
• To ensure safe storage of the control unit, it should be inserted in the designated
opening [2] on the drive unit (see chapter 2.6).
Persons with a pacemaker should not come within 20 centimetres of
the control unit, in order to avoid possible malfunctions and resultant
harm to health.
2.6 Storing the control unit
If the drive unit and control unit have been removed from the wheelchair, we recommend
stowing the control unit in the drive unit for safe storage.
• Make sure that the control unit is switched off.
• Insert the control unit into the designated compartment [2] in the drive unit.
• There is an opening in the compartment [2]. If the drive unit battery is charged while
the control unit is in the compartment [2], you can monitor the LED display [14] and,
consequently, the charging progress without having to remove the control unit.
If you take the via GO on board an aircraft with you: You need to insert the control unit
in the compartment [2] on the drive unit in such a way that the On/Off switch is pro-
tected against inadvertent actuation.
Werbung
Inhaltsverzeichnis
