Switching Off The Via Go; Setting The Speed - Alber via GO V24 Gebrauchsanweisung

10

2.8 Switching off the via GO

The via GO should be switched off at the end of a trip, not least to conserve the battery's
energy reserves.
Press the On/Off button [13] briefly to switch off the via GO. The button's green colour-
ing and the LED display [14] go out. If the via GO is then removed from the wheelchair,
it is also necessary to remove the control unit (see chapter 2.5).

2.9. Setting the speed

The maximum speed to be reached by the via GO can be set on the control unit as a cus-
tomised setting.
• Switch on the via GO by pressing the button [13] for at least 1 second. Then wait
briefly until the system check is complete.
• Pressing the button [11] increases the speed in steps of 0.5 km/h; pressing the but-
ton [12] decreases the speed in steps of 0.5 km/h. These increments are displayed as
followed on the LED display [14].
LED element Selected speed
14a flashes 1.5 km/h
14a and 14b flash 2.0 km/h
14b flashes 2.5 km/h
14b and 14c flash 3.0 km/h
14c flashes 3.5 km/h
14c and 14d flash 4.0 km/h
14d flashes 4.5 km/h
14d and 14e flash 5.0 km/h
14e flashes 5.5 km/h
The speed you have selected is saved automatically and is unchanged as
the setting each time you switch on the via GO.